Search results

Mitsubishi i-MiEV Forum

Help Support Mitsubishi i-MiEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. T

    Has anyone removed Air Con unit

    Just wondering if anyone has re-used the Air Con compressor (or whole system) in another car? Does it only run at 330V? I am parting out a 2011 i-miev and wondered if I could re-use it, but I will probably be running at a lower voltage. Can't find much tech info on the compressor etc. Thanks...
  2. T

    Help with scanned error codes

    For anyone wondering, I managed to get to the "ready" stage after recharging the 12V battery. It seemed to reset the system and cleared the way for everything to work. I couldn't drive it, as it had a flat tire, and the oil had been drained from the trans. I did want to check the motor would...
  3. T

    Help with scanned error codes

    Yes I'm aware of that, I just happened to take that pic while i was moving through the gears to check the dash was showing the correct gear as per the shifter. I'm not getting the ready light, obviously there's still a few errors to be ironed out, just got to work out what they are. Perhaps its...
  4. T

    Help with scanned error codes

    We repaired the sensor switch, and now it's back on and the correct gear is shown on the dash when moving through the gears. Unfortunately I still can't get it to run as some other error is preventing operation. There is a constant alert sound that starts a little while after turning the...
  5. T

    Help with scanned error codes

    Thanks for that Kiev, I will look into those links and think about whether it is worthwhile pursuing.
  6. T

    Help with scanned error codes

    Well I removed the shift position switch, and it appears to be pretty damaged. See below pics before and after dismantling. I assume this part will be either expensive or impossible to replace without ordering from Japan, so I might just start stripping the car without knowing if the motor etc...
  7. T

    Help with scanned error codes

    You're keen eyes are right. Shows up clearly with the flash.
  8. T

    Help with scanned error codes

    No the gear indicator isn't showing on the dash at all. We will try and play around with the wiring and connections on the weekend.
  9. T

    Help with scanned error codes

    If you mean the black connection to the gearbox as shown in the below picture, then no we didn't touch that. Is that the shift sensor you're talking about? The grease is just from when the CV joint was busted open.
  10. T

    Help with scanned error codes

    This is after we took the wheel off and reinserted the drive shaft into the CV joint and the motor.
  11. T

    Help with scanned error codes

    Thanks for the tips. That connection appears to be sound. Here's some pics of that area and of the rear damage.
  12. T

    Help with scanned error codes

    No, surprisingly the airbags didn't deploy. I'm not sure how to upload pictures to this forum but have some of the back damage. I couldn't see any damage to the motor casing or connections, but will have to have a closer look. I don't have the scanner at the moment so can't do those tests...
  13. T

    Help with scanned error codes

    Hi kiev and thanks for your welcome and prompt response. I'm in Australia and the car is a 2011 model, with 80,000km on the odometer and was involved in a rear end smash, which then also caused damage to the front. One of the rear CV joints was broken open but i've put it back in so that the...
  14. T

    Help with scanned error codes

    Hi all I have a salvaged i-miev wreck that I am trying to diagnose. Can anyone shed some light on the following error codes? U1113 P0705 U1116 U1111 Do you require any further information? Thanks in advance.
Back
Top