Recent content by martig

I finally replaced the heater and that fixed the issue. I’m currently dissecting the old heater to see what failed. So far the electronics seems that be fine.

kiev, thank you for the corrected manual pages. The fluid level is ok. The pump is working. Everything is working on AC power. Recently I had a chance to drive a 2012 Nissan Leaf. The heating seems 10x more powerful than on the i-Miev. So I’m thinking something must be wrong with the PTC heater.

Hi, I have an issue with the PTC heater. It works if I do the preheating with the remote. It also stays on when I go driving afterwards. If I don't use preheating then the heater doesn't produce any heat while driving. If I use OBS2 dongle and hobDrive I can see that in the beginning the...

That's great. As far as I understand the front sensors have a different shape than the rear. I need to replace one of the front wheel bearings. I hope I can remove the sensor without trouble. EDIT: When looking at the product pictures I realised it would probably fit the front because the bolt...

My understanding is that the left and right are the same. I guess I’ll have to see if I can find a second hand sensor locally. According to this site Bosch and TRW also made this sensor, but I have not been able to find the actual products anywhere —> https://partinfo.org/mitsubishi-4670a541/

I had the front right wheel bearing replaced and the ABS sensor was damaged during the procedure. So now I’m looking for a new one. The OEM part costs over 200 €. I would like something cheaper, but I have not managed to find a compatible third party sensor. I’m wondering if Mitsubishi used the...

Hi, I think it was pin 13. The effect is that it's showing the RPM as -4xxx when the car is not moving. I managed to get the car running for a while until I decided to open up the connector again. Bad idea, couldn't get it working afterwards. Anyway, now my plan is to replace the connector. So...

I found the connector. The manufacturer is Sumitomo - https://www.ebay.co.uk/itm/Sumitomo-6189-1092-13-WAY-CONNECTOR-KIT-Inc-Terminals-seals-13-AC001/233467142995

Actually, a 13 pin connector.

I managed to get the car running for a moment by sticking some thin wire into the corroded pin. This didn’t last for very long. I think I need a new 14 pin female connector. Do you have any idea where I could get one? The other option would be removing the connector and soldering the wires...

One of the pins on the female connector was really packed with green corrosion. Couldn’t really even insert anything. I used a drill bit that went into the other pins without effort. I tried leaving it in vinegar for half an hour, but it didn’t really work. I will try again today. The...

Hi, Thank you for the advice. I managed to open the connector and measure the resistances of the resolver coils. Fortunately they were all within spec. I discovered that one of the contacts was terribly corroded. I had to use a 0.4 mm drill bit to clean it out. Now there are no resolver/motor...

Hi, Has anyone experienced this error code, what was the solution? The manual tells first to check the motor plug. How can I open the plug? I don’t see any tabs.

Hi, I spent some time trying various parameters, but was not able to calculate the CRC or find the algorithm. The algorithm can be anything. Also, only a part of the VIN number might be used for the calculation. It doesn't even have to be a CRC algorithm. Can just be addition of all the hex...

Hi, I'm also interested in this topic. I found this program --> https://reveng.sourceforge.io/ I tried to use the VIN/CRC combination posted in this thread to find the algorithm, but I didn't get any results. I think it needs at least 4 samples. Maybe if you could find more samples then it...