Recent content by Ghost128k

Mitsubishi i-MiEV Forum

Help Support Mitsubishi i-MiEV Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. G

    read canbus with power off

    thanks for your reply. how i can monitorize remotely the canion? i plug permanent the obd2 in the car, but i see that when i power off the car, canion say "not connected" in a red label. In canion i see that there is a config option in settings tab that say "charging finished notification". in...
  2. G

    read canbus with power off

    Hello, i´m trying to connect the obd2 with a raspberry pi by bluetooth to read the SoC and stop the charge at a certaint % of SoC. When the car is "ready" work perfectly, the raspberry can read the canbus through obd2 and get the SoC. But i see that when the car is off, the conection betwen the...
  3. G

    replace 8 pack cells and bms

    hello, we suspect that the cmu of the ion was the cause of the 8 cells gets 0,00V. This is because with canion was not detect any issue in the "Bat status". Now we Will mount again the old cmd and see if Works well, until see how renumber the new cmu with lexía software. Many thanks in advace.
  4. G

    replace 8 pack cells and bms

    many thanks!. we Will try to recode with lexía 3 and share it ;)
  5. G

    replace 8 pack cells and bms

    good morning, recently in spain we can change a eight cells plus the circuit of it´s battery pack to a peugeot ion, because the circuit was broken and all the eight lev-50 cells became to low voltage. Then we replace the pack with a i-miev and see that the whole battery pack was 357 volts aprox...
  6. G

    Decyphering iMiEV and iON CAR-CAN message data

    many thanks for the code! i try it with the raspberry as soon as posible and tell the results. Thanks again.
  7. G

    Decyphering iMiEV and iON CAR-CAN message data

    dear sirs, i'm reading the post and i´d like to read the can-bus data with a raspberry pi in python. At this time i can connect via bluetooth and seria port profile the raspberry with the obdlink lx. Also i try the following python script, but i´m not sure what protocol use the imiev/psa car...
  8. G

    terms of baterry warranty

    Dear sirs, has anione a pdf with the terms of battery warranty? we would like to send a letter to the PSA group to increase the battery warranty at least equal to the mitsubitshi ones (10 years/100.000km) and we would like to show the mitsubitshi terms of warranty. Here in spain, we are notice...
  9. G

    Wanted: Single LEV50 cell, or full 8/4 cell module

    hello, if you are interesting in a lev-50 cell, we recently found in deuchland a person with has the entire battery pack of a citroen c-zero car, and in a group, we buy 12 cells, the total amount was aprox 420 euros including the package send to spain. if you need the name, please send me a PM...
  10. G

    pcb on 8 modules cell pack

    Yesenia That are the two PCB! We think That the right one is a BMs and the left Washington unknow Thanks a lot
  11. G

    pcb on 8 modules cell pack

    Dear sirs, we have received from deuchland a pack with 8 cells to replace a defective one over a peugeot ion. when we open the module appears BMS and other pcb that we dont knowk about it: this is the numbers over the unknow pcb: p/n 9499A795 s/n 01000008756 type: G8D-795M-4 pwr(A) pwr(b) ver...
  12. G

    My Car is Only Charging Up to 12 Bars

    Bello everybody. Mi write from spain. We are a owners group of citroen/Peugeot (psa group) eléctric vehicle clones of the i-Kiev. Once person of our group seems a issue with cell #7, that is down and not charge. The car has 60000 kms now and out of warranty. In psa group the pack batery cost...
Back
Top