This may not be the correct place for this post - so if not, Admins, please do your Adminning
But I wanted to know if anyone had done any reverse engineering on the iMiev Can Bus.
I am looking for a way to have an Arduino interface to change some of the ramp and regenerative brake ramps on the 'E' mode of the iMiev.
Basically, re-mapping the accelerator pedal so that the car is looking at a usage set point (say, you can't accelerate more than the equivalent of 5 mi/kWh) , until you reach 80% of the pedal travel, and then it is 'back' to normal. And then, through the Arduino interface, you could modify the ramp within certain parameters.
Just wondering if anyone has ever done that?