Looking at your picture--do you have the BLUE and GREEN on the wrong Tabs? They appear to be reversed, but it is hard to see from that picture.
i think you have the secondary sides of the transformers correct. T5 and T6 are the secondary outputs of transformer 1; and T7 and T8 are outputs for trans 2.
The primary side is the T1A and T1B, which should have BLUE wires coming off the Faston tabs of the board and right next to the Y1 tab (yellow wire to T5).
The other primary wire is the T4A and T4B, which have GREEN wires in the Faston tab covers.
When i put them back together, i start at the bottom of the tabs with the GREENs, then the BLUEs, then Yellow1 and Black1, followed by Black 2 and Yellow 2.
The Output filter coils N and P, are the Gray and Red wires; those appear okay.